Results 1 to 3 of 3

Thread: ARB winch bumper mounting

  1. #1
    Join Date
    Jun 2010
    Laramie, WY

    ARB winch bumper mounting

    I'm purchasing a used arb bumper and have heard that they will twist when winching. I'm thinking of reinforcing the mount somehow. Anybody done this or have any ideas about it?

  2. #2
    Join Date
    Feb 2006
    Denver, Colorado
    Send me your e-mail address and I'll send you some picture showing how to beef up that bumper installation.

    Retired service manager, member of Solihull Society, SCLR, past member of the NCLR and the Santa Barbara 4Wheelers clubs.
    99 D2, 3" lift, CDL with Detroit,T.T. lockers, 4:11's,H.D. axles, custom ft/rear bumpers with sliders, a 9500 HSI Warn winch and 5 HID's.

    To DOWNLOAD the RAVE Manual, follow this link

    Rover Radio issues or IPOD Adapters

  3. #3
    Join Date
    Sep 2009
    Loomis, Ca
    Here is what I did. It takes a bit of fab work but basically the mounts you see fit inside the frame rails. There is a stock crush plate inside the frame that we knocked out where the stock bumper mounts. With that out of the way the mounts extend into the bumper past the first cross memeber. It also uses 4 bolts eache side instead of two. Not air-bag approved but plenty strong.
    Trail Checklist:

    Rubicon (Buck to Tahoe in the rain/snow), Hell Hole

    96 DI 5" RTE, GBR 4.11's, ARB Front and Rear, 35" KM2's, custom front bumper, custom rear bumper, Roof Rack, Bottorf Sliders, Superwinch, RTE steering skid, Custom front diff guard...other and more to come

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts